Features and abilities of our product
Our experience turned to your advantage
The quality control of edge banding
Three high resolution video cameras are used to check each edge
Three edge surfaces are analyzed – edge band, ~1-3 cm upper/lower surface
By using two analysis nodes, both opposite edges of a board are analyzed
Detached band
Geometric damages
Geometric damages
Geometric damages
Geometric damages
Rugged band
Rugged band
Rugged band
Rugged band
Rugged band
Scratches
Stains
Stains
Stains
Stains
Excess band
Excess band
Excess band
Excess band
Band absence
Band absence
Band absence
Band absence
Glue residue
Glue residue
Glue residue
Glue residue
Chipping
Chipping
Chipping
Chipping
Missing laminate
Missing laminate
Missing laminate
Missing laminate
The identified board defects
- Rugged band surface
- Scratches on the band
- Pressure mark
- Peeled surface
- Edge band not glued properely
- Geometric board damages
- Stained edge band
- Glue residue
- Chipping on the edges
- Missing laminate
- Missing edge band
The board's edge band crack/scratch quality control
- Four matrix cameras are used for each corner of a board
- The corners are analyzed after the edge band is placed and sized
- Two camaras motinor the front corners of a board, two monitor the back corners
The spots are identified. By adapting the lighting system to your needs, more defects can be analyzed, such as skid marks, scratches, stains, band absence.
The measurement and control of drilled holes in the edges of the board
The linear camera is used to check the drilled holes in the edge of a board (the longer edge)
The matrix camera is used to check the drilled holes in the narrow edge of a board
Two quality control nodes are used to analyze drilled holes on the opposite side of a board
The measurement and control of drilled holes on the surface of a board
High resolution linear cameras are used to check drilled holes on the surface of a board
Both surfaces of a board are analyzed
The identified damages of drilled holes
The change of drilled hole diameter because of the worn-out drills on the drilling machine
Undrilled holes
Scrapes around drilled holes (diameter changes)
Shifted drilled holes
Board surface quality control
- High resolution linear cameras are used
- Focused and difused light sources are used
- Detected defect list is constantly updated by performing research and adapting the system to the client's needs
The identified board's surface defects
- Shiny surface
- Spots, dots, dirty surfaces
- Lamminate cracks/scratches
- Skid marks
- Lamminate overlays
- Inclusions
- Blisters, laminate bumps
